Kenwood XD-500 - Manual (Page 27)

XD-750/700/550/500 (En)
2 7
Preparation section
Basic section
Application section
Knowledge sections
Selection of DOLBY NR
(Noise Reduction)
To end recording
Selection of the reverse mode
÷
Pressing the key pauses recording after leaving a non-recorded
space of about 4 seconds.
÷
If the key is pressed again in less than 4 seconds after it has been
pressed, recording resumes from that instant.
1Play (or tune) the input source to be
recorded.
2Start recording.
4. Select the source to be recorded.
5. Start recording.
÷ When the CD input is selected and if a disc
has been set in the CD player, its playback
starts immediately.
The Dolby NR system minimizes the hiss noise heard when
playing tape. When playing a tape prerecorded with Dolby
NR ON, be sure to set the DOLBY NR ON for playback.
DOLBY NR
Lit when “DOLBY NR” is ON.
Each press switches the modes as follows.
1 “ [”... Both sides are played back (recorded), and
then the tape stops.
2 “ ”” .. Both sides are played back endlessly.
(The tape stops after recording onto both
sides.)
3 “ “” .. Only one side is played back (recorded),
and then the tape stops.
Each press switches the modes as follows.
1 “DOLBY NR” ON. ..... DOLBY NR is used.
2 “DOLBY NR” OFF ..... DOLBY NR is not used.
Let's record
REV. MODE
REC/ARM
ECHO
T A P E
EX . BASS
B DOLBY NR DOLBY NR
Select an input source other than “TAPE”.
INPUT
4 4
REC/ARM
5 5
÷
Recording stops automatically when the tape
side(s) to be recorded have been fully recorded.
÷ The beat cancel function can be used when
recording MW broadcasts.
•
REV
C D ) 1 ) ) )
EX . BASS
:
B
The input source component to be recorded should be displayed.
REV.MODE
C D ) 1 3 6 2 8
EX . BASS
:
1
B
TOTAL
Lights