Konica Minolta 5430 DL 5440 DL 5450 - Manual (Page 140)

Main Unit Theory of Operation Fusing Section
2-103
II Comp
osition
/O
p
eration
F. Detection of media full in the exit tray (magicolor 5450 only)
• The Paper Full Sensor (PC20) detects the load capacity of output media in the Exit Tray.
• When the Paper Holding Plate is low, the edge of the Paper Holding Plate shades the
Paper Full Sensor (PC20.)
• When printing starts, the output media pushes up the Paper Holding Plate and the edge
of the Plate activates the Paper Full Sensor (PC20.)
• After all media is discharged, the Paper Holding Plate goes down and the edge of the
Plate shades the Paper Full Sensor (PC20.) If the sensor is shaded, the printed media is
judged to not have reached the maximum load capacity yet.
• After all media is discharged, if the output media in the Exit Tray keeps the Paper Holding
Plate up and the Paper Full Sensor (PC20) remains activated, the printed media is
judged to have reached the maximum load capacity, and the operation panel displays the
message “OUTPUT FULL REMOVE PAPER.”
• If the sensor detects that the Exit Tray is full, printing is stopped.
• The message “OUTPUT FULL REMOVE PAPER” is removed when the output media is
removed from the Exit Tray, which again shades the Paper Full Sensor (PC20).
4138T2C004DA
4138T2C003DA
4138T2C005DA
Paper Holding Plate
When the tray is full
Exit Tray
Paper Full Sensor (PC20) When the tray is empty
Media
Media
When media is loaded
5430DL_5440DL_5450_TO_PDF.book 103 ページ ２００５年４月１２日 火曜日 午後４時４９分