Kodak EasyShare Series 3 User Manual
Page 43
Troubleshooting
www.kodak.com/go/support
37
Nothing
happens when
you try to print
■
Check the power connections (
).
■
Remove the paper tray, check that paper is properly loaded, and re-install
(
■
If the Paper light glows steady amber, load paper (
).
■
Make sure the color cartridge is properly installed (
). If the Color
cartridge light is on, install a new cartridge.
Nothing
happens when
you try to print
(from docked
camera)
■
The camera is not properly seated on the connector. Reseat the camera
on the printer dock (
).
■
Re-establish the connection: remove, then reseat the camera on the
printer dock.
■
Make sure there is at least one picture in the camera’s internal memory
or memory card.
Nothing
happens when
you try to print
(from Kodak
card reader)
NOTE: The Kodak EasyShare printer dock series 3 is compatible with the Kodak 8-in-1
card reader and the Kodak 6-in-1 card reader (each sold separately). Other
Kodak USB card readers may work with the printer dock; however, other
manufacturers’ card readers are not supported.
■
Check the USB connections from the card reader to the printer dock
(
).
■
Re-establish the connection: disconnect, then reconnect the USB cable
from the card reader to the printer dock.
■
Make sure a memory card is inserted and that there is at least one
picture on the memory card.
Nothing
happens when
you try to print
(from PictBridge
compatible
device)
■
Check the USB connections from the PictBridge compatible device to the
printer dock (
).
■
Re-establish the connection: disconnect, then reconnect the USB cable
from the PictBridge compatible device to the printer dock.
■
Make sure there is at least one picture in the PictBridge compatible
device’s internal memory or memory card.
If...
Try the following