Kodak EasyShare Series 3 - Manual (Page 41)

Troubleshooting
www.kodak.com/go/support 35
Printing stops
during mid-print
(paper stops
feeding, and
Paper light may
blink) IMPORTANT: Use only Kodak color cartridge & paper kits for your
printer dock. Do not use inkjet paper.
■ Check the paper:
1 Remove the paper tray ( page 7 ).
2 Check the paper slot on the back of the printer dock.
3 Remove loose paper from the printer dock. If paper is jammed, see
page 34 .
4 Inspect the paper supply: make sure removable tabs have not been
detached from the paper. Reload with new paper if necessary.
5 Carefully "fan" the paper to keep the sheets from sticking together.
6 Reload the paper tray. Do not exceed the fill line.
7 Re-install the paper tray, then press to resume printing.
■ Clean the paper feed roller ( page 31 ).
Print is smudged ■ Fingerprints may be on glossy side of paper. Handle paper by the edges
or by the removable tabs (
page 5 ).
Print is spotted ■ Check to see if the paper is dirty, and use a dry, lint-free cloth to wipe
clean. For excessive dirt or debris, thoroughly clean the paper tray, and
load new paper (
page 6 ). Check and clean the paper feed roller if
necessary ( page 31 ).
NOTE: When storing paper, remove and close the paper tray and paper tray door to
keep dust and debris from collecting on the paper or inside the printer dock
(
page 5 ).
If... Try the following