Kodak EasyShare Series 3 User Manual
Page 17
Setting up your digital camera
www.kodak.com/go/support
11
Refreshing the Kodak EasyShare Ni-MH rechargeable
battery pack
NOTE: The battery refresh feature is intended for use with the Kodak EasyShare Ni-MH rechargeable
battery pack only. Li-Ion batteries do not require refreshing. For battery information for other brands
of ImageLink system compatible cameras, see the camera user’s guide.
If you are getting fewer than 20 pictures per charge with your Kodak EasyShare
Ni-MH rechargeable battery pack, follow the tips under
Extending battery life, page 9
.
If these don’t help, the battery pack needs to be refreshed. The refresh cycle
completely discharges the battery pack, then fully recharges it.
NOTE: A full refresh cycle takes up to 8 hours, depending on how much charge is left in the battery pack.
For best results, refresh the battery pack overnight; do not interrupt the discharge/recharge cycle.
1 Make sure the Ni-MH rechargeable battery pack is in the camera.
2 Place your EasyShare camera on the printer dock (see
3 Press and hold the Battery charging lights/Refresh
button,
,
until the Battery charging
lights begin flashing green (approximately 5
seconds).
The charging lights monitor the refresh status:
Descending blinking
green lights
Discharging battery pack (lights turn off as
discharging progresses).
Ascending steady
green lights
Charging battery pack (lights turn on as charging
progresses).
Charging is complete when all three lights are lit.