Kodak EASTMAN 3.2S - Manual (Page 25)

www.kodak.com/go/aiosupport 19
KODAK ESP 3.2 / 3.2s All-in-One Printers
Connecting and Using Wi-Fi Direct for a Mobile Device or Computer with WPS
1. Press .
2. Touch , then touch Network Settings .
3. Touch , then touch Manage Wi-Fi Direct .
4. Touch Connect a Device Using WPS .
IMPORTANT: Before you make a selection on the printer, make sure you know:
• the location of the push button on your mobile device or
computer — it will be a button on your device, or a virtual button in the device
software.
• where to generate a WPS Pin on your mobile device or computer.
5. Select one of these methods to connect your device:
6. To print from a mobile device, see Mobile Printing, page 61 .
7. To print or scan from a computer:
a. Go to www.kodak.com/go/esp3_2downloads (for ESP 3.2 Printers) or
www.kodak.com/go/esp3_2sdownloads (for ESP 3.2s Printers).
b. Select the All-in-One Printer Software for your operating system.
c. Follow the on-screen instructions to install the software. (The printer and
scanner drivers are installed when you install the software.)
d. To print, see Printing, page 50 . To scan, see Scanning, page 77 .
Push Button Configuration Enter a WPS Pin
NOTE: You will have two minutes to
press or select the WPS button.
a. Touch Push Button Configuration.
b. On your mobile device or computer,
press (or select) the WPS button.
c. Touch OK on your printer control
panel.
a. Touch Enter WPS Pin.
b. On your mobile device or
computer, locate the Pin screen
and generate a WPS Pin.
c. Enter the WPS Pin on your printer
control panel, then touch OK.