Replacing the printhead – Kodak EASTMAN 3.2S User Manual
Page 101
www.kodak.com/go/aiosupport
95
KODAK ESP 3.2 / 3.2s All-in-One Printers
Replacing the printhead
IMPORTANT:
Replacing the printhead is not a regular maintenance procedure. Replace
the printhead only if you receive a new printhead from Kodak.
1. Make sure your printer is on.
2. Lift the access door, and wait for the carriage to move to the access position.
3. Remove both ink cartridges and set them aside.
This manual is related to the following products: