Kodak XLS 8400 - Manual (Page 35)

Network Printer Parameters
4-10 Part No. 1H9613 June 1997
6. Press until “ETHERTALK:VERSION” appears.
7. Press Setup/Select.
8. Press until the version you want appears (VER:1 or
VER:2).
The currently selected version is indicated by an asterisk (*).
9. Press Setup/Select.
10. Press until “VER:EXIT” appears.
11. Press Setup/Select.
12. Press until “ETHERTALK:EXIT” appears.
13. Press until “SETUP:EXIT” appears.
14. Press Setup/Select.
Printer Parameters - TCP/IP
IP Address
Default: 000.000.000.000
If you are on an isolated, nonconformant IP network with no intent
to connect to the internet, you can make up IP addresses. If you
were to choose 100.100.100.001 for the printer/Network Interface
Card IP address, any other devices on your IP subnet should also
start with 100.100.100; for example, 100.100.100.002 or
100.100.100.003.
The IP Address is programmed from the printer’s front control/
display panel. It may be necessary to turn the printer off and on
after you set up the address for the Network Interface Card to
register it.
” “
” “
” “
” “
” “