Sony HDW-2000 - Manual (Page 34)

1-28
HDW-2000/M2000/M2000P/S2000/S2000P/M2100/M2100P, DVW-2000/2000P/M2000/M2000P
MSW-2000/A2000/A2000P/M2000/M2000P/M2000E/M2000EP/M2100/M2100P/M2100E/M2100EP
1-15-3. System Phase Alignment
An external reference video signal and analog composite
signal (DVW/MSW recorder only) must be input to this
unit after they are adjusted so that SC-H conforms to the
specifications.
When Connecting to a Digital Switcher
Fundamentally, the system phase adjustment is not neces-
sary.
Refer to the manual of the digital switcher for details.
When Connecting to an Analog Switcher
Perform the system phase adjustment according to the
manual of the analog switcher.
To adjust the system phase of this unit, open the P3 page
(VIDEO OUT CONTROL2 & MISC) and use the MULTI
CONTROL knob.
When adjusting (i.e. changing the settings), press the
button below to blink the current setting value, and then
turn the MULTI CONTROL knob.
Button Item (Display)
F1 SYSTEM SYNC PHASE (SYNC)
F2 SYSTEM SUBCARRIER PHASE (SC)
m
. Be sure to adjust in PB mode for the recorder.
The system phase does not change even if the SYNC/SC
is adjusted in the REC mode, but it changes when the
REC mode is shifted to the PB mode.
. The playback sound may be momentarily interrupted if
the SYNC/SC is adjusted during tape playback.
. For the HDW series, the system phase of HD input and
output can be adjusted in function menu Page 3.
. The system phase of SD output of both HDW, DVW and
MSW series can be adjusted in ITEM-719 and -720 of
the extended setup menu.
1-15. Settings and Adjustment when External Equipment is Connected
1-15-4. Setup Menu Settings
Video/Sync Delay Setting “ITEM-701” (DVW/MSW
recorder only)
Commonly, when integrating the menu into the editing
system, set to “VIDEO”.
To prevent the picture shift during EE/PB switching in the
VTR-to-VTR edit operation, this setup menu is also set to
“VIDEO”.
Analog Component Signal Format Setting “ITEM-
709” (59.94 Hz mode, 525/60 system only)
The input (SUB-ITEM-0) and output (SUB-ITEM-1) sides
are set to “D-1” or “B-CAM” according to the operating
system, respectively.
n
For the HDW series and MSW-M2100/M2100P/M2100E/
M2100EP, set only output side.
1-15-5. Other Settings
When make the following settings, please contact your
local Sony Sales Office/Service Center.
Setting When Combining with Editing Control
Unit PVE-500
When setting initial speed to extra slow playback at less
than
±0.03 time speed duaring DMC editing the unit as a
player, the setup extended menu ITEM-F34 setting should
be changed.
For detail of ITEM-F series, refer to the maintenance
manual volume-1 (Section 1).
Setting of Audio Channel and Data Length Mode
(MSW recorder only)
When changing the audio channel configuration of this
unit from 16 bit
x 8 ch (factory setting) to 24 bit x 4 ch,
change the setting of the menu M371 : DATA LENGTH in
the maintenance mode, refer to the maintenance manual
volume-1 (Section 3).