Sam4s ER-390M - Manual (Page 175)

ER-390M Program Mode Programming • 167
Program Scans
Since much time and energy has been invested in the planning and programming of your ER-390M, it is advisable to
print a hard copy of the final program for future reference. This copy should be kept in a safe place.
1. Turn the control lock to the P position.
2. To print a program scan, enter 1 5, press the SBTL key.
5 SBTL 1
3. In this step, there are three different ways to scan program information. One is
PLU, the other is Macro, and the third is Others.
PLU PROGRAM SCAN
To read single PLU program information, enter the number (1-1000) of the PLU and
press the same number and PLU key.
PLU
Enter the PLU#,
up to 15 digits
Enter the PLU#,
up to 15 digits
PLU
Press a PLU key on the keyboard and press same key again.
PLU 1 PLU 1
To read multiple PLU program information, enter the first number (1-1000) and press
PLU key. Press the last number (1-1000) and press PLU key
PLU
Enter the first
PLU#, up to 15
digits
Enter the last
PLU#, up to 15
digits
PLU
Press a PLU key on the keyboard.
PLU 1 PLU 10
MACRO PROGRAM SCAN
To read MACRO information, press the MACRO key to be scanned,
MACRO# MACRO#
Refer to the chart below and enter a digit to represent the segment of the program you
wish to print; press the X/TIME key. To see additional scan, repeat this operation.