Sam4s ER-390M - Manual (Page 108)

100 • Program Mode Programming ER-390M
System Option Programming
Refer to the “System Option Table” to review the system options. Read each option carefully to determine if you wish
to make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0, and
because your most likely option selections require a status setting of 0, you do not need to
program this section unless you wish to change the default status.
Programming a System Option:
1. Turn the control lock to the P position.
2. Enter 3 0, press the SBTL key.
3. Enter a system option address, and then press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more
than one decision to be made in an address, add the values representing your
choices for each decision and enter the sum. Press the SBTL key.
5. Repeat from step 3 for each system option you wish to change.
6. Press the CASH key to end system option programming.
System Option Flowchart
SBTL X/TIME
Status
CASH
Repeat for each
System Option
Option #
SBTL 0 3