Sharp MD-X60H - Manual (Page 7)

PREPARATION FOR USE
● Unplug the AC power lead from the AC socket before connecting or discon-
necting any component.
■ Speaker connection
Connect each speaker wire to the SPEAKER terminals as shown.
Use speakers with an impedance of 6 ohms or more, as lower impedance speakers
can damage the unit.
Caution:
● Connect the black wire to the minus ( − ) terminal, and the red wire to the plus
(+) terminal.
● Do not mix the right channel and left channel wiring when connecting the spea-
kers to the unit.
● Do not let bare speaker wires touch each other as this may damage the amplifier
and/or speakers.
■ Aerial connection
Supplied FM aerial
Connect the FM aerial wire to the FM 75 OHMS terminal and position the FM
aerial wire in the direction where the strongest signal can be received.
Supplied AM loop aerial
Connect the AM loop aerial wire to the AM LOOP socket. Position the AM loop
aerial for optimum reception.
Place the AM loop aerial on a shelf, etc., or attach it to a stand or a wall with
screws (not supplied).
Notes:
● Do not place the aerial on the main unit as it may result in noise pickup from
the internal digital electronics.
Place the aerial away from the unit for better reception.
● If the AM loop aerial and the FM aerial wire are placed near the AC power lead,
interference may result.
External FM aerial
Use an external FM aerial if you require better reception.
Consult your dealer.
1 2 3
1 2 3
Right speaker Left speaker
Red
Black
Red
Black
AM loop aerial FM aerial
External FM aerial
MD-X60H(SUK) TINSE0227AWZZ
6