Sharp MD-X60H - Manual (Page 13)

RADIO OPERATION
■ Tuning
1
Press the TUNER (BAND) button.
● The power will be turned on automatically, and the unit will enter the tuner mode.
2
Press the TUNER (BAND) button to select the desired frequency band. (FM
ST, FM or AM)
3
Press the TUNING ( 3 or 2 ) button to tune into the desired station.
1,2
1,2
3
4,5
Manual tuning:
Press the TUNING ( 3 or 2 ) button as many times as required to adjust the
tuner to the desired station.
Auto tuning:
When the TUNING ( 3 or 2 ) button is pressed for more than 0.5 seconds,
scanning will start automatically and the tuner will stop at the first receivable broad-
cast station.
Notes:
● When radio interference occurs during auto scan tuning, auto scan tuning may
stop automatically at that point.
● If a weak station signal is found during auto scan tuning, the station will be
skipped.
● To stop the auto tuning, press the TUNING ( 3 or 2 ) button again.
4
To receive an FM stereo transmission, press the ST-MODE button on the
remote control so that the "STEREO" indicator on the display lights up.
● "ST" will appear when an FM broadcast is in stereo.
5
If the FM reception is weak, press the ST-MODE button on the remote control
so that the "STEREO" indicator goes out.
● Although the reception changes to monaural, the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
Notes:
● The tuner memory will store the last station you were listening to in each band,
even when the unit is in the stand-by mode.
● If the unit’s AM/FM tuner interferes with the reception of a nearby TV or radio,
move the unit as far away from these items as possible.
Direct playback:
Just pressing the TUNER (BAND) button will turn on the power automatically.
The radio station you were listening to last will be tuned in.
MD-X60H(SUK) TINSE0227AWZZ
12