Sharp MD-X60H - Manual (Page 34)

(Continued)
■ APMS recording
1
Select tracks for APMS playback. (Page 23. Steps 1 - 6.)
2
Load a blank cassette into the cassette compartment.
3
Press the REVERSE MODE button.
... To record on only one side.
... To record on both sides.
4
Select the Dolby NR mode by pressing the DOLBY NR button.
● When recording with the Dolby NR system, turn on the G indicator.
● When not recording with the Dolby NR system, turn off the G indicator.
5
Recording from a CD:
Press the CD 0 TAPE button.
Recording from a MiniDisc:
Press the MD 0 TAPE button.
● Programmed tracks will be recorded in order. After the unit has finished recording
the last track, recording will stop automatically.
■ Recording from the built-in radio to a cassette tape
1
Tune in to the desired station. (Pages 12 - 13.)
2
Load a blank cassette into the cassette compartment.
● Wind past the tape leader which cannot be recorded on.
3
Press the REVERSE MODE button.
... To record on only one side.
... To record on both sides.
4
Select the Dolby NR mode by pressing the DOLBY NR button.
● When recording with the Dolby NR system, turn on the G indicator.
● When not recording with the Dolby NR system, turn off the G indicator.
5
Press the TAPE ● 6 button.
● " " will flash.
6
Press the 0 button to record side A (1), or the 1 button to record side B (2).
● To record on both sides, begin on side A (1).
When recording is finished on side A (1), the tape will switch over to side B (2)
automatically.
4
3
5
5
4 3
2
TAPE
TAPE
4
3
6
6
5
4
3
5
2
6
Beat cancel switch (on the rear panel)
If a whistling noise occurs when recording from an AM station, set the BEAT
CANCEL switch to A or B, whichever gives the best reception.
To stop recording:
Press the TAPE ■ button.
To interrupt recording:
Press the TAPE ● 6 button.
Press the TAPE 0 button or TAPE 1 button again to resume recording.
MD-X60H(SUK) TINSE0227AWZZ
33