Sharp MD-X60H - Manual (Page 20)

(Continued)
2
4
3
■ EON-TI
1
Tune in the desired RDS station (when a PS name is being displayed).
2
Press the EON button when "EON" appears.
● "PTY.TI" and "SELECT" will appear alternately for about 4 seconds.
3
Whilst they are being displayed, select the TI (Traffic Information) using the jog
dial.
● The selected "TI" will flash.
4
Within 4 seconds, press the ENTER button.
● "TI" and "WAITING" will appear for 2 seconds each.
● "TI" will appear, and the unit will enter the EON-TI stand-by mode.
5
When a TA specifed starts on another network station, the unit will automatically
switch to that station, and "TI" will flash.
6
When the traffic announcement is over, the unit will automatically return to the
original station you were tuned to.
Note:
● If the EON button is pressed when "EON" is not displayed, "NO EON" will appear
for 4 seconds to indicate that the unit cannot enter the EON stand-by mode.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button. ("TI" → "WAITING")
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button. Within 4 seconds, press
it again. The EON stand-by mode will be cancelled.
● "TI" will go out.
Note:
● If neither "TP" nor "TA" appear, then even if "EON" appears the unit cannot
enter the EON-TI stand-by mode. In this condition, even if the EON button is
pressed, "NO TI" will flash for 4 seconds.
Notes:
● During the same programme as the specified PTY (or TA) is being
broadcast on the station you are receiving, the unit will not switch
to other network station.
● If there are more than two other network stations you want to listen
to, compare the strength of each station’s signal and tune in the
station with the strongest signal. (EON-AF)
However, if the frequency of other network station has been stored
in the preset channel memory, the unit will switch to that preset
channel.
● If you want to cancel the reception of an ON (other network) station
which was tuned in by the EON system and return to the original
station you were receiving, press the EON button.
● After the unit returns to the original station, the stand-by mode will
still be active. (The "TI" or "PTY" will remain lit.)
● The unit will not switch from the ON station to another network sta-
tion. The unit returns to the original station.
● When the unit switches automatically to other network station, if other
network station has any problem, or when the unit can no longer
receive that station with something wrong, "NO READY" will appear,
and then the unit will return to the original station.
1
2
3
4
5
MD-X60H(SUK) TINSE0227AWZZ
19