Sharp MD-X60H - Manual (Page 42)

HOW TO USE THE BUILT-IN TIMER
● Before setting the timer, make sure that the clock setting is correct. (Page 8)
● The start time and stop time, which are set with this operation, will be kept in memory until the AC power lead is unplugged or the setting is
changed.
ENTER
TIMER/
DELETE
2
3,4
5
6
7
8
9
10
11,12
■ To select the timer playback mode
Before timer playback, the following preparations are required.
● Load a CD, MD or Tape.
● Select a CD to be played.
● Preset the radio station.
1
Press the TIMER/DELETE button.
2
Within 10 seconds, turn the jog dial so that the "TIMER SET" display appears.
3
Within 10 seconds, press the ENTER button.
4
Select "TIMER PLAY" by using the jog dial.
5
Press the ENTER button.
● The start time setting display will appear.
6
Turn the jog dial to set the hour at which to start, and then press the ENTER
button.
7
Turn the jog dial to set the minute at which to start, and then press the ENTER
button.
● If not set manually, the ending time will be automatically set for one hour after
the starting time.
8
Turn the jog dial to set the hour at which to stop, and then press the ENTER
button.
9
Turn the jog dial to set the minute at which to stop, and then press the ENTER
button.
10 Turn the jog dial to select the function.
● If TUNER is selected, press the ENTER button, then select the preset number
using the jog dial.
● When no stations have been programmed, "NO PRESET" will be displayed, and
the programme operation will end. In this case, programme some stations and
then reprogramme from the beginning.
11 Press the ENTER button.
12 Adjust the sound level using the jog dial.
13 Press the ENTER button.
● Be careful not to turn the volume up too high.
(When the start time is reached in timer playback, the volume will increase
gradually to the level previously set.)
To change the timer setting:
Start again from steps 1 - 13.
■ Setting timer playback
1
Press the TIMER/DELETE button.
● Turn the jog dial so that the "T-STANDBY" display appears.
● If the start and stop times have not been set, the "T-STANDBY" display does
not appear. Set the time.
2
Press the ENTER button.
● The settings will appear in order, and the unit will enter the timer playback
stand-by mode. (The unit will enter the stand-by mode.)
Jog dial
1
2
CD TAPE TUNER AUX 1 AUX 2 AUX OPT. MD
MD-X60H(SUK) TINSE0227AWZZ
41