Sharp MD-X60H - Manual (Page 24)

(Continued)
■ APMS (Automatic Programmable Music Selector)
CD
1 -3
CD
CD
MD
CD
CLEAR
MD
PROGRAM
DIRECT KEY
MD
1
Select the desired programme source, CD or MD, by pressing the CD ■ or
MD ■ button.
2
Press the PROGRAM button.
● "PROGRAM" will flash.
3
If you have selected CD, press one of the buttons (1 0 - 3 0 ) to select the
disc to be played.
4
Use the DIRECT KEY to select the desired track number.
5
Repeat steps 3 and 4 for any other tracks. (Repeat step 4 only for MDs). Up
to 20 MD tracks or 32 CD tracks can be programmed.
● To select another track on an MD or on the same CD, skip step 3.
● The programmed playback order and the total playing time of the programmed
tracks will be automatically displayed, and only those track numbers will appear
in the music schedule.
● If the total playing time of the programmed tracks exceeds 999 minutes 59
seconds, "--:--" will be displayed. In this case, the programmed tracks are stored.
(only for CDs).
● If the total playing time of the programmed tracks exceeds 255 minutes 59
seconds, "255:59" will be displayed. In this case, the programmed tracks are
stored. (only for MDs).
6
Press the CD ■ or MD ■ button.
● "PROGRAM" will appear.
7
Press the CD 0 6 or MD 0 6 button to start playback of the programmed
selections.
● After all of the programmed tracks have finished playback, the unit will automat-
ically stop.
To clear the programmed selections:
Press the CLEAR button whilst the "PROGRAM" indicator is flashing.
● Each time the button is pressed, one track will be cleared, beginning with the
last track programmed.
To cancel the APMS:
Whilst the unit is stopped in the APMS mode, press the CLEAR button to turn off
the "PROGRAM" display.
● The programme contents will be erased.
● When you open the disc tray or a MiniDisc is removed, the APMS mode will be
cancelled.
To check which tracks are programmed:
Whilst the unit is stopped in the APMS mode, turn the jog dial. Or press the 5
or 4 button on the remote control.
● When the jog dial is turned clockwise, the next track number will appear. When
it is turned anti-clockwise, the previous track number will appear.
Adding tracks to the programme
If a programme has been previously stored, the "PROGRAM" indicator will be
displayed. Then follow steps 2 - 6 to add additional tracks, the newly selected
tracks will be stored after the last track of the original programme.
2
4
6
Notes:
● It is not possible to insert an additional track between programmed tracks that
have already been entered.
● Programming and cancelling are not possible during playback or in the pause
mode.
(Remote control operation)
Playback order
MD-X60H(SUK) TINSE0227AWZZ
23