Silvercrest SBB850EDSA1-02/10-V3 - Manual (Page 13)

- 11 -
• To reassemble the appliance lid ᕢ, guide the
hinge cams through the opening of the hinge
guides.
Baking moulds and kneading paddles
The surfaces of the baking mould
¶ and kneading
paddles
² have a non-stick coating. When clea-
ning the appliance do not use aggressive deter-
gents, cleaning powders or objects that may cause
scratches to the surfaces.
Due to moisture and vapours the surfaces of
various parts may undergo changes in their appe-
arance over a period of time. This has no influence
on the function nor does it reduce the quality of the
baking results.
Before cleaning, take the baking mould ¶ and
kneading paddles
² out of the baking area.
Wipe the outside of the baking mould ¶ with a
moist cloth.
ƽ
Important
Never submerse the baking mould ¶ in water or
other liquids.
Clean the interior areas of the baking mould
¶
with warm soapy water.
If the kneading paddles
² are encrusted and it is
difficult to dissolve, fill the baking mould ¶ with hot
water for approx. 30 minutes.
If the mountings of the kneading paddles
² are
clogged, you can clean them carefully with a wooden
toothpick.
Do not use any chemical cleaning agents or solvents
to clean the Bread Baking Machine.
Technical data
Model: Bread Baking Machine
SBB 850 EDS A1
Nominal voltage: 220-240V~50Hz
Power consumption: 850 Watt
Disposal
Do not dispose of the appliance in
your normal domestic waste. This pro-
duct is subject to the European guideli-
ne 2002/96/EC.
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Dispose of all packaging materials in an
environmentally friendly manner.
IB_49385_UK_4.qxd 06.05.2010 10:37 Uhr Seite 11