Sony BRC-300P - Manual (Page 46)

In
s
ta
llat
ion
a
nd
Conne
c
tio
ns
Installation
46
8
Connect the cables to the connectors on the rear of
the camera.
Note
Take the proper steps to ensure that the load of the
cables connected does not cause problems.
To remove the camera
1
Remove the three screws used to attach the camera
in step 7 of “Installation on a ceiling (example).”
2
Turn the camera with the bracket counterclockwise
to remove.
Installation on a shelf, etc. in a high
position (example)
1
Loosen the four screws on the bottom of the camera
to remove the four feet.
2
Attach the ceiling bracket (A) to the bottom of the
camera using the supplied four screws (3M3
×
8).
Align the screw holes on the bottom of the camera
with those in the ceiling bracket, and attach the
bracket to the camera.
Tighten the screws a little at a time in the numbered
order shown in the illustration. Attach the supplied
wire rope using the screw designated as number 4.
After all of the screws have been temporarily
tightened, securely tighten each one in turn.
Note
For attaching the camera to the ceiling brackets, use only
the supplied screws. Using other screws may damage the
camera.
Ceiling
Attach the wire
rope at the same
time.
3M3 × 8 (supplied)
Ceiling bracket (A)
1
4
3
2