Sharp FO-6700 - Manual (Page 169)

Optional Settings
167
6. O
p
ti
on
Setti
ngs
Option Setting 33, Separate Mode, is turned on, the selections will be
1
for UPPER CASSETTE or 2 for LOWER CASSETTE.) Paper will
always be drawn from this source unless the source runs out of paper.
The 2ND PRIORITY setting now appears to let you select the source
in the event that the “1st priority” source runs out of paper. The
selections will vary depending on your selection for the “1st priority”
source. Check the selections that appear in the display and enter the
desired number. If you want to have the incoming fax received to
memory instead of printing it on paper from another source, select
NONE.
If you did not select NONE and Option Setting 33 (Separate Mode) is
turned off, the 3RD PRIORITY setting now appears. This setting lets
you choose whether the incoming fax is printed using paper from the
3rd source or received to memory in the event that the “2nd priority”
source also runs out of paper. Enter 1 to select the 3rd source, or 2
(NONE) to have the incoming fax received to memory.
♦ Initial setting: 1
Setting 17: RETRANSMISSION TIMES
This sets the number of times the fax will reattempt a memory
transmission which has been interrupted by a line error or power
failure. Enter any 2-digit number from 01 to 14, or enter 00 to turn off
the function.
♦ Initial setting: 10
Setting 18: RETRANSMISSION INTERVAL
You can select the number of minutes the fax waits between each
memory retransmission attempt. Enter 01 for 1 minute, 02 for 2
minutes, etc., up to a maximum of 15 minutes. If you do not want the
fax to wait between attempts, enter 00.
♦ Initial setting: 02
all-FO6700.book Page 167 Wednesday, August 30, 2000 1:17 PM