Symbol Technologies LS 3070 - Manual (Page 19)

2-7
LS 3070 Product Reference Guide: Setup
Occasionally, there can be excessive interference on a channel from some other
source of radio transmissions. In this case, the default channel of a system can
be changed using the parameter codes for
Set Transmission Frequency. If you
find a particular scanner/base pair has trouble communicating over a normal
operating distance, try setting different transmission frequencies to see if
performance improves. (The LS 3070 system changes channels automatically if
it encounters interference as much as 80% of the time over a continuous 5-
minute period.)
Note: To set trasmission frequency correctly, be sure to
use the correct Select Channel Number bar code for
your country, and to set a channel within the
allowable range.
Installing a Magstripe Reader
If desired, install a magstripe reader. This may be done before or after pairing.
1. Remove the blank plug in the magstripe connection port on the base/
charger, and then plug the magstripe reader’s cable into this port, as
illustrated below.
2. The purpose of the blank plug is to protect the base/charger from
accidental damage that can be caused by static electrical discharge into the
magstripe connection port. Keep this plug in the port whenever the magstripe
reader is not connected.
Magstripe
Reader
Connection
Port