Silex technology Print/Scanner/Storage Wireless Server PRICOM C-6400W - Manual (Page 66)

4 Appendix
Users Manual CX2
11. Connect the USB memory to the
PRICOM C-6400W, and boot the
PRICOM C-6400W. Click
Next
.
- The PRICOM C-6400W will read the
configuration saved on USB memory
and then will reboot. The PRICOM C-
6400W will take about 15 seconds to
reboot. Do not disconnect the USB
memory while rebooting.
12. Check the LED status. Click
Next
.
- The LED status will depend on the
configuration. Verify the correct
configuration.
The PRICOM C-6400W configuration is complete. You can continue to install the PRICOM-
Print CX2. Or, the PRICOM USB Utility. If you are done, click
Finish
to quit the wizard.If you
reinstall the PRICOM-Print CX2, to a PC which has already installed the PRICOM-Print
CX2, you can use the printer port, which you have already created.
If you continue to install Print application, follow step 13.
- If you select Cancel and quit the wizard, you can install the print application later directly form
the menu screen.