Siemens CCIC1410 - Manual (Page 59)

Configuration with the CCIC1410 Homepage
59
Siemens Building Technologies
Fire Safety & Security Products 05.2009
Multicast settings for stream 1 / Multicast settings for stream 2:
Select Always multicast to enable multicast for stream 1 or stream 2. Unicast
video transmission delivers a stream through point-to-point transmission; multicast,
on the other hand, sends a stream to the multicast group address and allows
multiple clients to acquire the stream by requesting a copy from the Multicast group
address.
The five ports can be changed between 1025 and 65535. The multicast RTP port
must be even-numbered and the multicast RTCP port number is always the
multicast RTP port number plus one, and thus it is always odd-numbered. When
the multicast RTP port changes, the multicast RTCP port will change accordingly.
If the multicast RTP video ports are incorrectly assigned, a warning message is
displayed.
Multicast TTL [1 – 255]: The multicast TTL (Time to live) is the value that tells the
router the time range within which a packet can be forwarded.
NOTE
To utilize the RTSP streaming authentication, make sure that you have set a password for the network
camera first.
9.8 Wireless LAN settings (CCIC1410-LAW only)
1. Open the CCIC1410 Homepage (see chapter 9.1).
2. Choose the Configuration menu.
3. On the left hand side, choose the menu item Wireless LAN.
4. Define the settings, for more information see below.
5. Click Save.
SSID (Service Set Identifier):
"SSID" is a name that identifies a wireless network. Access points and wireless
clients attempting to connect to a specific WLAN (Wireless Local Area Network)
must use the same SSID. The default setting is "default". Note: The maximum
length of SSID is 32 single-byte characters.