Servis-Rhino 95HD - Manual (Page 32)

F3788-7-04 Maintenance Section 5-4
BUCKET TOOTH POINTS
Bucket tooth points are self sharpening and will require
little attention. However, points can be replaced when
they become badly worn or broken.
If a tooth shank breaks off, becoming lost or damaged so
that it cannot hold a tooth point, a new shank should be
welded to bucket.
TIGHTENING NUTS AND BOLTS
Periodically check to be sure all bolts and nuts are tight
(See torque chart page 5-10).
Check all pivot pins for cotter pins, washers and retainers.
If any are missing replace them.
LUBRICATION
Economical and efficient operation of backhoe is
dependent upon regular and proper lubrication of all
moving parts with a quality lubricant.
All parts provided with grease fittings should be lubricated
with a good quality chassis lube type grease. If any grease
fittings are missing, replace them immediately. Clean all
fittings thoroughly before using grease gun.
Lubricate all 27 grease fittings at least twice daily (See
chart for locations), once at the beginning of operation
and again approximately half way through the work day.
Grease hourly any joints that operate in water.
Control valve handle linkage should be oiled with SAE 30
oil.
IMPORTANT: Avoid excessive greasing. Dirt collects on
exposed grease and greatly increases wear. After
greasing wipe off excess grease from fittings.
MAINTENANCE
Item No. Location Description Qty. Total
1 Stabilizer Arm 2
2 Rod, Stabilizer Cylinders 2
3 Rod, Swing Cylinders 2
4 Base, Stabilizer Cylinders 2
5 Base, Boom Cylinder 1
6 Rod, Boom Cylinder 1
7 Base, Dipperstick Cylinder 1
8 Rod, Dipperstick Cylinder 1
9 Boom-Dipperstick Pivot 1
10 Base, Bucket Cylinder 1
11 Rod, Bucket Cylinder 1
12 Guide Link - Dipperstick 1
13 Dipperstick-Bucket Pivot 1
14 Swing Post 2
15 Boom to Swing Frame 1
16 Swing Cylinder Base 4
17 Bucket Link - Cylinder 2
18 Bucket Link - Bucket 1
LUBRICATION CHART
MAINTENANCE
Spring
Pin
Point
Shank
Heavy Duty
© 2004 Alamo Group Inc.