Servis-Rhino 95HD - Manual (Page 10)

F3788-7-04 Safety Section 1-7
SAFETY HAZARD SIGNAL WORDS
SAFETY
SAFETY
THIS SAFETY SYMBOL MEANS
ATTENTION!
BECOME ALERT!
YOUR SAFETY IS
INVOLVED!
There are three levels of hazard intensity identified by
signal words DANGER, WARNING and CAUTION. The
level of hazard intensity is identified by the following
definitions.
DANGER - Immediate hazards which will result in severe
injury or death.
WARNING - Hazards or unsafe practices which could result
in minor personal injury or death.
CAUTION - Hazards or unsafe practices which could result
in minor personal injury or property damage.
WARNING
CAUTION
Never interfere with factory-set hydraulic calibrations. Any change in
calibration could cause a failure of the equipment and result in injury.
Always shut the Power Unit completely down, place the transmission in
park, and set the parking brake before you or anyone else attempts to
connect or disconnect the Backhoe.
Never crawl under a raised implement supported solely by the Power Unit
boom. Release of the control lever or mechanical failure will result in the
Implement falling and possible injury or death. Always securely block up
the Implement before crawling underneath to perform repairs and
service.
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the implement. Place the Backhoe on the ground or securely
supported on blocks or stands, disengage the auxiliary hydraulics and
turn off engine. Push and pull the control levers several times to relieve
pressure prior to starting any maintenance or repair work.
WARNING!
WARNING!
DANGER!
DANGER!
© 2004 Alamo Group Inc.