Sony PCS-1P - Manual (Page 67)

3-5
PCS-1/PCS-1P
Teleconference
terminal A
Teleconference
terminal B
DHCP
server A
DHCP
server B
Router Router
LAN1 LAN2
3-3. Connection via DHCP
Example of system
When a call is initiated from teleconference terminal A to teleconference terminal B.
1. The LAN set menu of teleconference terminal B is set as described below.
DHCP mode: ON
Host name: Enter any name.
IP address: Blank
Network mask: Blank
Gateway address: Blank
DNS address: Blank
Gatekeeper used: OFF
Gatekeeper address: Blank
User name: Blank
User number: Blank
SNMP service: OFF
Trap transmission destination: Blank
Community name: public
Description of device: Videoconference Device
Installation place: Blank
Contact of administrator: Blank
NAT setting: OFF
NAT address: Blank
Packet retransmission request: Blank
Optimum rate control:
OFF (Set to ON when a packet loss occurs frequently.)
Port number used: Specified value (Set to “User setting” when a port number is specified
by the network administrator.)
TCP port number: 2253 (Enter the port number specified by the network administrator
when the port number used is set to “User setting”.)
UDP port number: 49152 (Enter the port number specified by the network administrator
when the port number used is set to “User setting”.)
2. Confirm that the IP address displayed in the launcher menu of teleconference terminal B is
192.100.20.20.