Standard Horizon PHANTOM Series PS2000 - Manual (Page 40)

Phantom PS2000 Page 40
3 : 15 times
2 : 10 times
1 : 5 times
5. Press the [CALL(SET)MENU]key to store the selected setting.
6. To exit this menu and return to radio operation mode press the [16/9] key.
The Phantom PS2000 has the capability to turn off the Individual or Group call
ringer.
1. Press and hold down the [CALL(SET)MENU] key
until “ RADIO SETUP ” menu appears.
2. Press the [ ] key to select “ DSC SETUP ” menu,
then press the [CALL(SET)MENU] key.
3. Press the [ ] or [ ] key to select “ DSC BEEP ” menu,
then press the [CALL(SET)MENU] key.
4. Press the [ ] or [ ] key to select “ INDIVIDUAL ” if
you wish to disable the Individual call ringer, or
“
GROUP ” if you wish to disable the Group call ringer,
then press the [CALL(SET)MENU] key.
5. Press the [ ] or [ ] key to select “oF.”
6. Press the [CALL(SET)MENU] key to store the se-
lected setting.
7. To exit this menu and return to radio operation mode press the [16/9] key.
If you wish to return to enabling the ringer tone, just repeat the above proce-
dure, pressing the [
] or [ ] key to select “on” in step “5” above.
11.5.4 Transmitting an Individual Call
This feature allows the user to contact another vessel with a DSC radio. This
feature is similar to calling a vessel on CH16 and requesting to go to another
channel.
1. Press the [CALL(SET)MENU] key. The DSC Op-
eration menu will appear.
2. Press the [ ] or [ ] key to select “ INDIVIDUAL ”
menu, then press the [CALL(SET)MENU] key. The
transceiver will beep, and the “Individual directory”
will appear. (To cancel, press the [16/9] key)
3. Press the [ ] or [ ] key to select the “Individual”
you want to contact.
4. Press the [CALL(SET)MENU] key to transmit the
individual DSC signal.
5. After INDIVIDUAL CALL is transmitted, the trans-
ceiver will wait 8 seconds for the acknowledgment.