Standard Horizon PHANTOM Series PS2000 - Manual (Page 39)

Page 39 Phantom PS2000
11. Repeat step 10 as many times as necessary to com-
plete the MMSI code (nine digits).
12 Press and hold the [CALL(SET)MENU] key to store
the individual address.
12. To enter another individual address, repeat steps 5 through
12.
13. To exit this menu and return to radio operation mode press the [16/9] key.
11.5.2 Setting up Individual Reply
Allows setting up the radio to automatically (default setting) or manually re-
spond to a DSC Individual call requesting you to switch to a working channel for
voice communications. When Manual is selected the MMSI of the calling ves-
sel is shown allowing you to see who is calling. This function is similar to caller
id on a cellular phone.
1. Press and hold down the [CALL(SET)MENU] key
until “ RADIO SETUP ” menu appears.
2. Press the [ ] key to select “ DSC SETUP ” menu,
then press the [CALL(SET)MENU] key.
3. Press the [ ] or [ ] key to select “ INDIVIDUAL RE-
PLY ” menu, then press the [CALL(SET)MENU] key.
4. Press the [ ] or [ ] key to select “ AU (Automatic)”
or “ oF (Manual).”
5. Press the [CALL(SET)MENU]key to store the selected set-
ting.
6. To exit this menu and return to radio operation mode press the [16/9] key.
11.5.3 Setting up the Individual / Group Call Ringer
When a Individual Call or Group Call is received the radio will produce a ringing
tone for 3 minutes. This selection allows the Individual / Group Call ringer time
to be changed.
1. Press and hold down the [CALL(SET)MENU] key
until “ RADIO SETUP ” menu appears.
2. Press the [ ] key to select “ DSC SETUP ” menu,
then press the [CALL(SET)MENU] key.
3. Press the [ ] or [ ] key to select “ INDIVIDUAL
RENGER ” menu, then press the [CALL(SET)MENU]
key.
4. Press the [ ] or [ ] key to select ringing time of a
Individual/Group Call.
4 : 3 minutes continuously