Standard Horizon PHANTOM Series PS2000 - Manual (Page 31)

Page 31 Phantom PS2000
10.14 NAVIGATION INDICATION
The transceiver has the ability to display the time and your vessel position (LAT/
LOG), when connected to a GPS receiver.
1. Press the [NAV] key momentarily, display “time,” “latitude,” and “longitude”
informations alternately every
two seconds. If the GPS re-
ceiver is not receiving a fix, the
display will be shown “
NO POS ”
notation in the LCD.
2. To hide the navigation information, press the [NAV] key again.
You may display the COG (Course Over Ground) data in the
LCD instead of your vessel position (LAT/LOG) by the Radio
Setup Mode, refer to section “12.5 CHANGING GPS INFOR-
MATION TO VESSEL POSITION OR COF.”
10.15 INTERCOM OPERATION
If you connect the two CMP25 RAM+ Microphone to the Phantom PS2000,
you may communicate between the both CMP25 RAM+ Microphones.
10.15.1 Communication
1. Press and hold down the [DW(IC)] key until the channel
number is changed to “ IC ” notation. ThePhantom PS2000
is changed to “INTERCOM” mode from the “Radio” opera-
tion mode.
2. Press the PTT switch. “ TALK ” will be shown on the display.
NOTE: A warning beep will be emitted when the PTT switch
is pressed while the “LISTEN” notation is appeared.
3. Speak slowly and clearly into the microphone, hold the mi-
crophone about 1/2 inch away from your mouth.
4. When finished, release the PTT switch.
5. To exit the “INTERCOM” mode and return to “Radio” opera-
tion mode, press the [DW(IC)] key again.
10.16.2 Calling
Press and hold the [DW(IC)] key for one second when the “INTERCOM” opera-
tion is activated, a calling beep is emitted twice from the transceiver speaker.
(Time) (Longitude)
(No GPS Signal)
(Latitude)