Standard Horizon PHANTOM Series PS2000 - Manual (Page 28)

Phantom PS2000 Page 28
10.12.3 Priority Scanning (P-SCAN)
In the default setting, Channel 16 is set as the priority channel. You may change
the priority channel to the desired channel from the Channel 16 by the Radio
Setup Mode, refer to section “12.7 PRIORITY CHANNEL SET.”
1. Set the squelch level to the “squelch threshold” (the background noise is
disappeared).
2. Select a desired channel to be scanned using the [ ] or [ ]
key, then press and hold the [SCAN] key. “MEM” will appear
on the LCD which indicates the channel has been pro-
grammed into the transceivers memory.
3. Repeat step 2 for all the desired channels to be scanned.
4. To DELETE a channel from the transceiver’s memory, select the channel
then press and hold the [SCAN] key, “MEM” will disappear in the LCD.
5. To start priority scanning, press the [SCAN] key momantarily
(“ P-SCAN ” appears on the LCD). Scanning will proceed be-
tween the memorized channels and the priority channel. CH
16 the priority channel will be scanned after each pro-
grammed channel.
6. To stop scanning, press the [SCAN], [16/9], [WX], or PTT key.
You may change the scan resume time by the Radio Setup Mode, refer to
section “12.9 SCAN RESUME TIME.”
MEM CH. CH. 16 MEM CH. CH. 16 MEM CH. CH. 16