Sanyo PJLINK PLC-XL51 - Manual (Page 64)

64
Maintenance and Cleaning
Be sure to reset the Lamp replacement counter after the lamp is replaced. When the Lamp replacement
counter is reset, the LAMP REPLACE indicator stops lighting.
Turn the projector on and press the MENU button
to display the On-Screen Menu. Use the Point 7 8
buttons to move the red frame pointer to the Setting
Menu icon.
Use the Point ed buttons to move the red frame
pointer to Lamp counter and then press the SELECT
button. The first dialog box appears showing the total
accumulated lamp time and reset option. If you select
Reset, “Lamp replacement counter Reset?” appears.
Select “Yes” to continue.
1
2
Another confirmation dialog box appears, and select
“Yes” to reset the Lamp replacement counter.
3
This projector uses a high-pressure lamp which must be handled carefully and properly. Improper handling
may result in accidents, injury, or create a fire hazard.
l Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee
of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time
than other similar lamps.
l If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights
up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.
(Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of
the lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.
l A Lamp may explode as a result of vibration, shock, or degradation as a result of hours of use, as it
comes to the end of life. Risk of explosion may differ according to the environment or conditions in
which the projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETy PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an
authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check
carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out
from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one
should check the inside of the projector except those who are authorized trained technicians and who
are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those
who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken
glass.
LAMP HANDLING PRECAUTIONS
Lamp Replacement Counter
✔ Note:
• Do not reset the Lamp replacement counter without
implementing lamp replacement. Be sure to reset the
Lamp replacement counter only after replacing the lamp.
Select “Yes,” then
another confirmation
box appears.
Select “Yes” again to
reset the lamp counter.
To reset the lamp counter,
move the pointer to Reset and
then press the SELECT button.
the “Lamp replacement
counter Reset?” dialog box
appears.