Sanyo PJLINK PLC-XL51 - Manual (Page 46)

46
Display
Blue back
Press the Point 7 8 buttons to switch on/off. When this
function is “On,” a blue image is displayed while the input
signal is not detected.
Press the Point 7 8 buttons to switch on/off. This function
decides to display the On-Screen Displays.
On ………………… Display all the On-Screen Displays. Use this
function when you want to project images
after the lamp becomes bright enough. This
mode is set as a default.
Countdown off… Display the input image instead of the
countdown when turning on the projector.
Use this function when you want
to project the image as early as possible even
when the lamp is not bright enough.
Off………………… Do not show the On-Screen Displays. except:
l
On-Screen Menu
l
“Power off?”
l
P-Timer
l
“No signal” for Power management item (p.50)
l
”Please wait...”
l
Arrows for panning mode (p.36)
Setting
Uniformity adj.
This function adjusts the brightness uniformity on a screen.
Select either Store 1, Store 2 or Reset with the Point 7
8 buttons, and then press the SELECT button. Press the
Point 7 8 buttons to adjust the brightness uniformity (from
0 to 7).
Store 1…… Store the uniformity adjustment even when the
projector is turned off. Reset the uniformity
adjustment when the AC power cord is unplugged.
Store 2…… Store the uniformity adjustment even when the
projector is turned off or the AC power cord is
unplugged.
Reset…….. Reset the Uniformity adjustment when the
projector is turned off or the AC power cord is
unplugged.
✔ Note:
• Sometimes, the brightness uniformity can not be
adjusted under certain conditions. With the adjustment
of brightness uniformity, the balance of color or contrast
also changes.