Sony UP-CR20L - Manual (Page 28)

28
Replacing the Paper Roll and Ink Ribbon
Chap
te
r 2
Pr
epa
ra
tio
n
s
2
Pull the ribbon on the white spool, attach one edge of
a strip of adhesive tape along the entire length of the
ribbon’s end, and then attach the other edge of the tape
to the ribbon on the black spool.
3
Remove any slack from the ribbon.
Be sure to wind the taped portion completely onto the
black spool so that the tape is not exposed.
4
Hold the center of the ribbon tray, and load it into the
unit.
Always hold the center of the ribbon tray when loading
it into the unit. If you hold the tray by any other part,
your fingers may get caught while inserting the tray
and injuries may result.
5
Close the ribbon door.
Depending on the position of the ribbon break, a single
printout’s worth of ribbon may be lost.
Note
Note
A Wind the
spool to feed
the ribbon out.
B Attach the adhesive tape along
the entire length of the white
spool’s ribbon end, and attach it to
the ribbon on the black spool.
Wind the black spool to remove any slack.