Sony UP-CR20L - Manual (Page 26)

26
Replacing the Paper Roll and Ink Ribbon
Chap
te
r 2
Pr
epa
ra
tio
n
s
2
Enter the administrator password using the numeric
keypad, and touch [OK].
(The factory default setting for the password is
“9999.”)
The ribbon door unlocks, and the error message screen
returns. The key icon at the top right changes to “!,”
indicating that the door is unlocked.
Removing the Paper Roll and Ink
Ribbon
The above message is set to appear before the ink
ribbon and paper roll are completely used up. Even if
there is some ink ribbon and paper remaining, be sure
to load a new ink ribbon and paper roll.
1
Remove the output cover and output tray.
2
Remove and empty the scrap receptacle.
If the scrap receptacle becomes too full, scraps that are
cut off may be unable to eject. This may result in
malfunction. Be sure to empty the scrap receptacle
each time you replace the paper roll.
3
Press and lower the paper door lever, hold the paper
door at the center portion, and pull the door forward
until it locks into the open position.
Note
Note