Sony UP-CR20L - Manual (Page 22)

22
Loading the Paper Roll and Ink Ribbon
Chap
te
r 2
Pr
epa
ra
tio
n
s
5
Hold the center of the ribbon tray, and load it into the
unit.
• Always hold the center of the ribbon tray when
loading it into the unit. If you hold the tray by any
other part, your fingers may get caught while
inserting the tray and injuries may result.
• Be sure to insert the ribbon tray fully into the unit.
6
Close the ribbon door.
Notes on storage
• Avoid placing the unit where it will be subject to:
– high temperatures,
– high humidity or dust,
– direct sunlight.
• After opening the bag, use the ribbon and the paper as
soon as possible.
• When transporting or storing the paper roll and ink
ribbon after partial use, we recommend putting them
back into their respective bags.
Attaching the Scrap Receptacle
When printing, a margin of empty space is left between
each printout. These excess portions are cut off and
dropped into the scrap receptacle. Remove scraps from the
receptacle as soon as possible.
If the scrap receptacle becomes too full, scraps that are cut
off may be unable to eject. This may result in malfunction.
Remove scraps from the receptacle as soon as possible,
and be sure to empty the receptacle whenever you replace
a paper roll.
Attaching the Output Tray
When printing, printouts are ejected from the printer and
collect in the output tray.
1
Attach the output tray to the printer.
Notes
Note