Smeg Electric Multifunction SE290X-6 - Manual (Page 25)

Instructions for the User
8.2 Removing the door
8.2.1 With type 1 mobile levers
With the door completely open, lift the levers A of the two hinges until
they touch the hinges B and take hold of the two sides of the door with
both hands close to the hinges themselves. Raise the door to an angle of
about 45° and remove it. If the hinges have not locked, repeat the
operation, raising the levers and keeping the door slightly raised. To
reassemble, fit the hinges B into their grooves, then lower the door into
place, ensuring that it remains fitted into the grooves C, and lower the
levers A.
8.2.2 Removing doors with pins
Open the door completely and insert the pins (supplied) into the holes
from the inside. Close the door to an angle of about 45° and lift it off. To
reassemble, fit the hinges into their grooves, then lower the door into
place and extract the pins. If you should lose the pins, two screwdrivers
can also be used.
8.3 Oven door gasket
To allow thorough cleaning of the oven, the door
gasket can be removed. Before removing the gasket,
remove the oven door as described above. Once the
door has been removed, lift the tangs at the corners
as shown on the right.
After cleaning, put the gasket back in place with the
longest side horizontal and insert the tangs into the
holes provided, starting with the ones at the top.
52