Sharp SD-HX600 - Manual (Page 72)

E-67
SD_HX600_SEC_SECL_E6.fm 04/3/15
ENGLISH
TINSKA016AWZZ
SD-HX600
Re
fe
re
nc
es
- T
roub
le
s
h
ooting c
h
a
rt -
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your autho-
rized SHARP dealer or service center.
! General
! Tuner
! AV selector
Symptom Possible cause Reference
page
No sound is heard. " Is the volume level set to "0"? P. 20
" Are the headphones connected? P. 65
" Are the speaker wires disconnect-
ed? P. 15
" Is the correct function selected for
the AV selector? P. 62
The sounds from speakers
are not well balanced. " Are the speaker wires connected to
the wrong channels? P. 15
Noise is heard during play-
back. " Move the unit away from any com-
puters or mobile phones.
When a button is pressed,
the unit does not respond. " Set this unit to the power stand-by
mode and then turn it back on. If the
unit still malfunctions, reset it. P. 69
Interference or noise occurs
on the TV image. " Is the unit placed near TV with inter-
nal antenna? Use an outdoor anten-
na. P. 16
Timer playback does not
start. " Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock and timer. P. 19, 53
"CLOCK ADJUST" appears
when checking the clock. " Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock. P. 19
The display on the unit is
dark. " Is the display in the dimmer mode? P. 20
The power is not turned on. " Is the unit unplugged? P. 18
No images are displayed. " Is TV turned on? P. 56
" Is the input of TV switched? P. 56
" Is the correct function selected for
the AV selector? P. 62
Symptom Possible cause Reference
page
The radio makes unusual
noises continuously. " Is the unit placed near the TV or
computer?
" Is the FM antenna or AM loop anten-
na placed properly? Move the an-
tenna away from the AC power cord
or the unit if located near. P. 16
The preset channel cannot
be recalled. " Did you remove the plug from the
AC outlet, or did a power failure oc-
cur? P. 38
Preset the channel again.
Symptom Possible cause Reference
page
No image appears on a TV,
or images from the source
equipment do not appear. " Is the same function selected for the
main unit and AV selector? P. 22, 62
Image cannot be played
back. (Sound is not heard.) " Is the same function selected for the
main unit and AV selector? P. 62
" Are the video and audio cables con-
nected improperly? P. 13, 61
" Is the AV selector turned on? P. 18
After recording, contents are
not recorded on DVD-R,
DVD-RW discs or video-
tapes. " Are the source equipment and target
equipment connected properly? P. 61, 63
" Is the same function selected for the
main unit and AV selector? P. 62 - 64
" Is the correct channel selected for
the target equipment? P. 63
" Are you recording material with copy
protection? P. 62 - 64
" Is the source equipment connected
with a component video cable? P. 64
" Is the source equipment connected
with a digital audio cable? P. 64