Sharp SD-HX600 - Manual (Page 60)

E-55
SD_HX600_SEC_SECL_E5.fm 04/3/15
ENGLISH
TINSKA016AWZZ
SD-HX600
Ad
v
a
nced
F
e
atures
- Sl
e
e
p
t
ime
r -
Sleep timer
The unit turns off at a specified time when listening to a disc or the radio. To confirm the remaining sleep time:
" The remaining sleep time is displayed for about 10 seconds.
" You can change the remaining sleep time while it is displayed by pressing the
ENTER button (steps 3 - 4).
To cancel the sleep operation:
Press the ON/STAND-BY button on the main unit while "SLEEP" is indicated.
To cancel the sleep operation without setting the unit to the stand-by mode, proceed
as follows.
! To use timer and sleep operation together
For example, you can fall asleep to the radio, and wake up to CD.
1
During playback, set the MODE 1/MODE 2 switch to MODE 2 and
press the TIMER/SLEEP button.
2
Within 10 seconds, press the or button to
select "SLEEP SET", and press the ENTER
button.
3
Press the or button to select the time.
(Maximum: 2 hours - Minimum: 1 minute)
" 2 hours - 5 minutes 5-minute intervals
" 5 minutes - 1 minute 1-minute intervals
4
Press the ENTER button.
" The unit will enter the power stand-by mode auto-
matically after the preset time has elapsed.
" The volume will be turned down 1 minute before the sleep operation finishes,
and then you cannot change the volume.
1 While "SLEEP" appears, set the MODE 1/MODE 2 switch to MODE 2 and press
the TIMER/SLEEP button.
2 Within 10 seconds, press the or button to select "SLEEP".
Remaining sleep time
1 Set the MODE 1/MODE 2 switch to MODE 2 and press
the TIMER/SLEEP button.
2 Within 10 seconds, press the or button to select
"SLEEP OFF".
3 Within 10 seconds, press the ENTER button.
("SLEEP" goes out.)
1 Set the sleep time (steps 1 - 4).
2 Set the timer playback (steps 1 - 8, page 53).
Make sure timer playback does not start while sleep timer is active.
The unit enters into the power stand-by mode after the time set for sleep timer, and
turns on at the start time of timer playback.
Sleep timer setting
Timer playback setting
Timer playback
starts. Timer playback will
automatically stop. Sleep operation will
automatically stop. Sleep operation
starts.
Desired time 1minute - 2hours
Start time Finish time
1 minute - 2 hours
1
2