Sharp SD-HX600 - Manual (Page 23)

E-18
SD_HX600_SEC_SECL_E1.fm 04/3/15
ENGLISH
TINSKA016AWZZ
F
S
V
I
N
P
E
E
SD-HX600
Pr
epara
tion f
o
r Us
e
- Re
mot
e
c
ontr
o
l /
A
C
po
we
r c
onne
c
tion -
Remote control
! Battery installation
Precautions for battery use:
" Replace all old batteries with new ones at the same time.
" Do not mix old and new batteries.
" Remove the batteries if the unit will not be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
" Do not use rechargeable batteries (nickel-cadmium battery, etc.).
" Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
" Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
" Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
" Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
" Keep the remote control away from moisture, heat, shock, and vibrations.
! Test of the remote control
AC power connection
! Connecting the AC power cord
After checking all the connections have been made correctly, plug the AC power cord
of the amplifier unit and the AV selector into the AC outlet.
Note:
Unplug the AC power cord from the AC outlet if the unit will not be in use for a pro-
longed period of time.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.
! To turn the power on
If the power does not turn on, check if the power cords are plugged in properly.
To set the main unit and amplifier unit to stand-by mode:
Press the ON/STAND-BY button on the main unit again.
To turn off the AV selector:
Press the POWER button on the AV selector again.
Notes:
" After the main unit and amplifier unit enters the power stand-by mode, wait a few
seconds to turn on again.
" To turn on the main unit, you can also use the ON/STAND-BY button on the
remote control.
" You cannot turn on/off the AV selector with the ON/STAND-BY button on the
remote control.
1 Open the battery cover.
2 Insert the supplied batteries
according to the direction in-
dicated in the battery com-
partment.
When inserting or removing the bat-
teries, push them toward the bat-
tery terminals.
3 Close the cover.
Point the remote control directly at the re-
mote sensor on the main unit.
The remote control can be used
within the range shown on the
right.
Press the ON/STAND-BY button. Does
the power turn on? Now, you can enjoy
your system.
Note:
The remote control may not work while the
disc door is open. Move closer to the main
unit, or aim the remote control from differ-
ent angles.
8" - 20'
(0.2 m - 6 m)
Remote
sensor
Main unit
1 Press the POWER button on the AV selector.
2 Press the ON/STAND-BY button on the main unit.
AC outlet
(AC 120 V, 60 Hz)
Main unit AV selector