Ad v a nced f e atures, Mounting the wall bracket on the wall – Sharp SD-HX600 User Manual
Page 65
E-60
SD_HX600_SEC_SECL_E6.fm
04/3/15
ENGLISH
TINSKA016AWZZ
F
S
V
I
N
P
E
E
SD-HX600
Ad
v
a
nced
F
e
atures
-
M
ount
in
g the
u
n
it on the
wa
ll -
!
Mounting the wall bracket on the wall
VESA (*) compliant fittings (commercially available) can be attached to the wall
bracket.
Fittings are not supplied, but can be purchased.
Note:
Types of fittings:
Fittings must satisfy the following.
"
Compatible with the VESA standard.
"
Have a gap of 3.973" (100 mm) 3.973" (100 mm) between the screw holes on the
section to be attached.
"
Sturdy and stable to prevent fall or breakage.
How to attach fittings
"
There are four VESA (*) screw holes on the wall bracket. You can use commer-
cially available fittings for mounting.
"
Follow the method recommended by the bracket manufacturer.
Warning:
"
Install brackets properly following the operation manual. Improper installation may
cause the main unit to fall leading to injury or breakage.
"
To ensure a proper installation, contact your dealer or installer.
"
During installation, be careful not to pinch your fingers.
"
The wall should be strong enough to support the weight of the main unit. (Install
on a reinforced part.)
"
Do not impose an extra load on fittings. It may cause the main unit to fall leading to
injury or breakage.
"
Do not modify or change the wall bracket. It may cause the main unit to fall leading
to injury or breakage.
Caution:
"
Do not block the ventilation opening of the main unit with a tablecloth, etc. Heat
may be kept inside causing fire.
"
Select a mounting position carefully to avoid injury by hitting head.
"
Never step on or hang from the main unit. Pay special attention to children. It may
cause injury or breakage to the main unit.
"
Check the wall strength. SHARP is not liable for accidents caused by insuffi-
cient strength of the wall or improper mounting.
"
Improper mounting may cause the main unit to fall. If you need assistance,
contact your dealer or installer.
(*)
VESA (Video Electronics Standards Association) is an organization to promote
the standardization of digital imaging device for PCs.
3.973" (100 mm)
3.973"
(100 mm)