Siemens 4110 - Manual (Page 89)

88
Appendix
Gigaset 4110isdn, GBR, A31008-G4110-B102-2-7619 Anhang.fm 4.9.02
There is no display of
units/costs. No charge rate informa-
tion supplied. Apply to the phone
company to have meter-
ing pulses transmitted.
There is no display of
call costs. Cost
per unit = 0. Set cost per unit
(page 67).
I can’t hear anything. The key has been
pressed – the micro-
phone has been
“muted.”
Press œ to resume
your conversation.
The caller’s number is
not displayed. Call number transmis-
sion has been barred. The caller must apply
to his/her provider to
enable transmission of
the number.
No numbers can be
dialled. The long-distance code
has changed.
The phone has been
locked.
Check and correct the
long-distance code
(page 33).
Check the status dis-
plays, unlock the phone if
necessary (page 15).
No calls are being
received. “Permanent” call for-
warding has been acti-
vated.
The MSN has not been
assigned to the internal
user.
The “internal” class-of-
service has been set.
Deactivate “perma-
nent” call forwarding
(page 55).
Specify the receive MSN
(page 27).
Change the class-of-ser-
vice (page 79).
The forwarding condi-
tions are not displayed
for call forwarding. Internal forwarding has
been activated. Activate “external” for-
warding (page 54).
Apply to your provider to
enable this.
The phone also rings
when there are fax/PC
calls. The call number is in the
base phone’s call num-
ber list. Delete the relevant call
number (MSN) from the
list (page 24).
No call charges are dis-
played. Call charge display has
not been activated or this
feature has not been en-
abled by your provider. Activate call charge dis-
play (page 67).
Apply to your provider to
enable the “Charge
transmission” feature.
For PABXs:
There is no connection or
a wrong connection after
dialling a call number. The access code has not
be entered or has been
entered incorrectly. Check and correct the
access code (page 82).
Question Possible cause Possible solution