Siemens 4110 - Manual (Page 30)

29
Setting up ISDN call numbers (MSN)
Gigaset 4110isdn, GBR, A31008-G4110-B102-2-7619 MSN.fm 4.9.02
Step
by
step
Setting up ISDN call numbers
(MSN)
Your ISDN connection provides you with 2 phone lines (B-channels) that can be
used at the same time. You can set up a maximum of 10 own call numbers
(MSN) on your base station. If you have not yet stored all the call numbers us-
ing the installation assistant (see page 26), you can do this now. All call num-
bers stored subsequently will automatically be assigned to all registered
handsets.
Set up call number (MSN)
Every newly set up call number will automatically be given its own ringer mel-
ody, which you can change individually. This will allow you to tell straight away
from the ring tone who the call is intended for.
Press * for selection menus.
Select using [ Z ] and [OK ]: Base Settings → Settings → ISDN settings →
Set up MSN .
Select using [ Z ] and [ | ]: (required MSN).
Select using [ Z ] and [OK ]: Edit entry .
In this menu, you also have the option of setting another ringer melody and of
deleting or displaying the entry.
Enter new or modified MSN and/or names and confirm with [ | ].
Select using [ Z ] and [OK ]: Save entry .
Assigning call numbers (MSNs)
You can now assign the registered handsets the previously set up call numbers
(MSN). In doing so you will specify
● the call numbers (there can be more than one) under which a registered ter-
minal will ring (receive MSN),
● the call number from which an internal subscriber should dial (outgoing
MSN). You can set one outgoing MSN for each internal subscriber. This
MSN is displayed to the called party and any call charges incurred are as-
signed to the appropriate subscriber (see also the table on page 24).
Assigning an incoming MSN
A newly registered handset will ring under all configured call numbers. If you
want to assign a specific incoming MSN to the handset:
Press * for selection menus.
Select using [ Z ] and [OK ]: Base Settings → Settings → Setup user →
Setup device .
Select using [ Z ] and [ | ]: (required internal subscriber).
Select using [ Z ] and [OK ]: Receive MSN → (relevant MSN).
Now use [  ] and [OK ] to activate the required Receive MSN
(
'
in front of the menu item = ON/without = OFF).
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.