Siemens 4110 - Manual (Page 85)

84
Operation using a telephone system
Gigaset 4110isdn, GBR, A31008-G4110-B102-2-7619 Wahloptionen.fm 4.9.02
Step
by
Step
Activate the keypad for the next call only
All dialling characters ( 0 - 9 , * , # ) are sent as a keypad character sequence when
the next connection is made (dialling and call). When connected, the keypad
is retained and the unit does not automatically switch to tone dialling (DTMF).
* is pressed for menus.
Press [
Z ] and [OK ] to select: Base Settings → Call preparat. → Temp. keypad
(
'
before menu item = ON / none = OFF).
Special requirements
If you encounter problems when connecting your Gigaset 4110/isdn behind
your ISDN PBX, such as:
- handset does not ring to signal incoming calls, or
- a fault message is displayed
you should consider the following essential requirements:
First requirement:
Each Gigaset terminal (handset) requires a separate send MSN.
1st step
Store 1 internal MSN of your PBX for each Gigaset terminal.
* is pressed for menus.
Press [
Z ] and [OK ] to select: Base Settings → Settings → ISDN settings →
Set up MSN .
2nd step
Assign each Gigaset terminal one of the previously stored MSNs as the send
MSN (such as “Internal 0” to “Internal 2”).
* is pressed for menus.
Press [
Z ] and [OK ] to select: Base Settings → Settings → System settings →
Setup user → Setup device → Press [ ) ] to open the additional menu → Send
MSN .
Second requirement:
It is not possible for several MSNs of the Gigaset to be called simultaneously
from your PBX.
To ensure that the registered handsets can ring at the same time when a call
arrives, first make the following setting:
3rd step
Store another internal MSN of your PBX in your Gigaset 4110isdn. This internal
MSN of your PBX serves as a call group address for Gigaset terminals that can
be combined in step 2.
* is pressed for menus.
Press [
Z ] and [OK ] to select: Base Settings → Settings → ISDN settings →
Set up MSN .
1.
2.
1.
2.
1.
2.
1.
2.