Siemens HIPATH 5000 - Manual (Page 29)

Making Calls – Convenience Functions
29
Step by Step
After a Speaker Call (Announcement) in a
Group
If this function has been configured (contact the service
personnel), you can use a speaker call (announcement,
Æ Page 22) to announce a call in progress to a group of
users
Æ Page 47.
After a member of the group has accepted the call re-
quest, you can transfer the waiting party.
Precondition: You are conducting a call.
qld
Press the key. LED flashes. Enter the code.
o w
Enter the group’s station number.
s
Announce the call.
When a member of the group accepts the call, you are
connected to this party.
t
Replace the handset.
Trunk Flash (Not for HiPath 500)
To activate ISDN-type services and features through the
network carrier’s analog trunks or those of other com-
munications platforms (such as "consultation hold"), you
must send a signal to the trunks before dialing the ser-
vice code or telephone number.
Precondition: You have set up an external connection
via an analog line.
qie
Press the key. LED flashes. Enter the code.
o
Enter the service code and/or telephone number.
Consultation
If the connection between the two other parties
is not established within 45 seconds, the call
from the first party returns to you (recall).
Consultation