Sony BRS-200 - Manual (Page 42)

42
Installation and Connection of the Switcher
Ch
apt
er 3 Prep
ar
at
ion
s
5
Reinstall the top panel of the Processor Unit using the 14 screws removed
in step 1.
Tighten the screws in the order A, B, C, D, E, and F.
6
Reset the setting data of the switcher to the factory preset settings.
Display menu page 955, turn the F2 control to display “ Reboot” under
“FACT SET,” then press the F2 control. The setting data stored in the
switcher will be reset to the factory preset settings.
When an optional interface board has been installed or removed, be sure to
reset the setting data to the factory preset settings before operating the
switcher.
To remove the interface board
Remove the interface board in reverse order.
Connecting the Processor Unit and Control Panel
Be sure to turn off all the equipment before connection.
Note
C
D
B
A
F
E
E
F
Note