Sony BRS-200 - Manual (Page 141)

141
Menu List
App
end
ix
900 UTILITY.. 960 REMOTE.. 962 CONTROL Off, On Sets up the REMOTE connector.
BAUD 9600, 19200, 38400
PARITY None, Even, Odd
APPLY Exec
LAN.. 963 IPADD 1.1 to 255.255 Sets up the IP address and network mask of
the switcher for communication with a
computer.
After entering the addresses in IPADD and
NET MASK, set FTP to Enable. When the F4
control (APPLY) is pressed, rebooting is
required to enable the setting.
NET MASK 0.0 to 255.255 (255.0)
FTP Disable, Enable
APPLY Exec
STATUS.. 970 FIRMVER.. 971 PR XX.XX (Version indication) Allows you to check the version of the
firmware.
CP XX.XX (Version indication)
FPGAVER1.. 972 GENLOCK XX.XX (Version indication) Allows you to check the version of the FPGA.
SDI I/O XX.XX (Version indication)
INPUT XX.XX (Version indication)
OUTPUT XX.XX (Version indication)
FPGAVER2.. 973 DVI XX.XX (Version indication) Allows you to check the version of the FPGA.
OPT IN1 XX.XX (Version indication)
OPT IN2 XX.XX (Version indication)
OPT OUT XX.XX (Version indication)
CODE.. 974 MACADD
H
0000 (MAC Address MSB
indication) Allows you to check the MAC address and
serial number.
MACADD L 00000000 (MAC Address
LSB indication)
SERIAL 123456 (product serial
number)
DIAG.. 975 FAN 1 OK, NG (indication) Allows you to check the condition of the fan.
FAN 2 OK, NG (indication)
FAN 3 OK, NG (indication)
FAN 4 OK, NG (indication)
OPTION.. 976 IN SLOT1 SDI, DVI, None (indication) Allows you to check the type of the interface
board installed in the switcher.
IN SLOT2 DVI, None (indication)
OUT SLOT DVI, None (indication)
REBOOT.. 980 REBOOT Exec Indicates the executing process.
• REBOOT: The switcher reboots when the
F1 control is pressed.
• SAVE: The SETUP setting data is saved
when the F2 control is pressed.
• CONTINUE: Nothing is executed, and the
menu display is restored when the F3
control is pressed.
SAVE Exec
CONTINUE Exec
Setting menu Setting item Description