Woodstock M1109 - Manual (Page 27)

-25-
M1109 Combo Lathe/Mill
O
PE
R
AT
IO
N
S
Using Manual Feed
You can manually move the cutting tool around the lathe/
mill with the three handwheels shown in Figure 36.
Longitudinal Handwheel
The longitudinal handwheel moves the carriage left or
right along the bed. This control is helpful when setting
up the machine for turning or when manual movement is
desired during turning operations.
Cross Feed Handwheel
The cross slide handwheel moves the top slide toward
and away from the work. Turning the dial clockwise
moves the slide toward the workpiece.
Compound Slide Handwheel
The compound slide handwheel controls the position of
the cutting tool relative to the workpiece. The graduated
dial is adjustable using the same method as the dial on
the cross slide. Angle adjustment is held by two hex nuts
on the base of the compound slide.
Figure 36. Carriage controls.
Cross Feed
Handwheel
Longitudinal
Handwheel
Compound
Slide
Handwheel