Woodstock M1109 - Manual (Page 16)

-14-
M1109 Combo Lathe/Mill
O
PE
R
AT
IO
N
S
LATHE OPERATIONS
General
TURN OFF and LOCK your master power
switch so no power is available to the
lathe/mill, and make sure the spindle
is stopped before proceeding with any
adjustments or maintenance. Failure to
comply may result in serious personal
injury or death.
Always wear safety glasses when oper-
ating this lathe/mill. Failure to comply
may result in serious eye injury caus-
ing blindness.
Power Supply
When illuminated, the power lamp ( Figure 14) indicates
that the power is being supplied to the lathe/mill. If you
press the red emergency stop button, you will cut power
for machine operations. Twisting the emergency stop but-
ton clockwise and letting it pop out will restore power
for machine operations and reset the switch.
Note: The Spindle Rotation ON/OFF Lever (Figure 13)
on the apron starts the spindle motor in a particular
direction.
Figure 14. Power lamp and emergency
stop location.
Emergency
Stop Button
The Model M1109 will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
If you are an inexperienced operator, we strongly rec-
ommend that you read books, trade articles, or seek
training from an experienced lathe/mill operator before
performing any unfamiliar operations. Above all, your
safety should come first!
Complete the Test Run and Break-In procedure on
Page 13 before using this lathe/mill for any cutting or
threading operations; otherwise, gear box damage will
occur.
NOTICE
Power Lamp
OFF
Spindle Jog
Button