Star Micronics 800C - Manual (Page 42)

33
Replacing the film roll
You must replace the film roll whenever you change from color to monochrome printing
(or the reverse) or whenever the film roll is used up. Follow the
Steps below to replace
the film roll.
Steps:
1. Make sure that the power switch is in
the OFF position.
2. Open the top cover of the printer while
the paper tray is in place. Use the Top
Cover Support bar to prop up the Top
Cover.
Caution: Always use the Top Cover Support Bar to prop open the Top Cover.
Caution: Always leave the paper tray in place when opening the printer's top
cover. Removing it while the top cover is open will cause it to fall shut
while your hands are inside the machine.
Caution: Do not touch the sensor located at the front left side inside the printer
when the printer's power is ON. Touching the sensor will cause the
gears to automatically rotate.
Do not touch this sensor