Star Micronics 800C - Manual (Page 16)

7
6. Place the larger half of the film roll into
the rear portion of the printer.
Fit the geared bobbin side into the slot
first. Then slip the other end into the
opposing slot. The smaller bobbin (on
the left side) should pop into place.
The bobbin and printer gears should
mesh.
Insert the take-up roll (smaller half) into
the slots in the front portion of the
machine by following the procedures
described above.
7. Gently rotate, toward the front of the
printer, the gear of the film roll to
take up any slack in the sheet.
8. Lay the Top Cover Support Bar down
to its original position while holding the
top cover with one hand.
9. Gently, but firmly, close the printer's top
cover by pushing down on it. When the
top cover properly closes, you will
hear the click of the latches.